CNC Machine Setup And Operation

CNC Machine Setup and Operation

Computer Numerical Control Machines are sophisticated instruments that only trained CNC operators should operate them. There are certain rules and guidelines to consider if you are planning to use a CNC machine by yourself.

CNC checklist before startup

Before starting up the Computer Numerical Control Machine, there are safety rules that must be considered first. First important aspect before starting up the CNC machine is to ensure your own safety, therefore wearing protective gear, such as eye glasses and short sleeved shirts is an important dress code during CNC operation. You should also be careful whenever you are handling tools and sharp edged work pieces to avoid any accidents. You must also ensure that the cutting tools are fastened in the machine spindle to avoid any movement during the cutting operation.

Actual Startup, Operation and Machine Setup of the CNC

The Computer Numerical Machine startup procedure varies depending with the type of machine being used but usually there is a main power switch or a circuit breaker to turn it on. Some machines also require hydraulics or air pressure before it starts up.

When the Computer Numerical Machine starts up, the machine usually starts at its Machine Home Position. The Machine Home Position allows the control and the machine to have a preset starting position for all its axes. After startup, the CNC machine must be sent to this position before the work begins. This position will later be changed to an appropriate location whenever you are machining a particular part of a product.

The Tool Length Offset Value or TLO is the distance from the tip of the tool from the spindle in the Home Position. The TLO must be set for each tool in the current job. The TLO can be set using a height gage, fixture location, as well as the reference tool. When these values are determined, they are stored in the Controller to be used during the program operation.

After setting the Tool Length Offset Value it is time to setup a part origin of a CNC machine. Setting up the part origin on a CNC machine is the same as setting up a conventional machine. It usually involves positioning the axes to a point where the plan designates as its origin. There are many ways to locate the position on the reference point, it is by using edge finders, wigglers or magnifying glasses.

After setting up the whole system for the Computer Numerical Control, it is time to Load the program to the machine. Program loading is different for each machine. Some machines have tape readers to input the program into the Computer Numerical Control Machine’s memory. Newer machines have internal or external floppy devices to input the program to the machine. After the program is loaded to the machine, the CNC machine is now ready to use.

There are certain instances when you have to change the tools in the Computer Numerical Control manually during machine operations. When a certain machining operation is complete, the program will move the aces to the tool change position and display the next tool needed. It is now the job of the Machine operator to remove and replace it with the next tool.

Extra Care must be taken whenever you are starting operations with the CNC machine, any mistake taken during the part of the operation may lead to serious injuries from the machine operator.